LILKNPA1-01 - AmEn.fm 4 - Warnings for use Page 7
4 WARNINGS FOR USE
The user MUST ALWAYS respect the following warnings:
VISUALLY FOLLOW all movements of the machine and its load remaining in-
side the typical working range of the radio remote control.
BE POSITIONED in a way that permits him to see the system “machine+radio
remote control”, and above all the load, in the best possible way.
Before using the radio remote control ALWAYS MAKE SURE that the STOP
pushbutton can be pressed and released: if it does not work, do not use the
radio remote control.
SWITCH OFF the transmitting unit when work is interrupted. Avoid leaving the
load suspended in the air (even when changing the battery).
NEVER LEAVE the transmitting unit unguarded when the starting keyswitch is
inserted.
SWITCH ON OR USE the transmitting unit only when starting work: improper
use could be hazardous.
NEVER SWITCH ON OR USE the transmitting unit in closed spaces, with the
machine not in sight, or outside the typical working range.
PRESS immediately the STOP pushbutton in case of hazard.
PAY ATTENTION to the entire work area. Press the STOP pushbutton in case
of hazard.
PAY ATTENTION not to let elements such as concrete, sand, lime, etc. deposit
on the transmitting unit because they can compromise transmitting unit use
and safety.
In case of malfunctions and/or damaged and/or faulty parts, PUT the radio re-
mote control out of use until the problem has been completely eliminated.
FAILURE TO COMPLY WITH THE ABOVE WARNINGS MAY RESULT IN SERI-
OUS INJURY OR DEATH TO PERSONNEL AND DAMAGE TO EQUIPMENT.
To Next Page
Loading...
Need help?
General
