Page 12 7 - Frequencies LILKNPA1-01 - AmEn.fm
7 FREQUENCIES
Radio frequency transmission of AUTEC radio remote controls operates inside fre-
quency bands permitted by European regulations that are valid when the radio re-
mote control is placed on the market.
Each radio remote control is programmed by the producer in the AUTOMATIC scan mode
(producer's standard programming) or MANUAL selection mode.
7.1 MANUAL SELECTION MODE
When operating in the MANUAL selection mode it is possible to work at a specific frequency
that must be set manually by programming the dip switches in the radio modules
(refer to
paragraph 8 "Programming").
To set or modify this operation mode contact authorised Autec personnel.
7.2 AUTOMATIC SCAN MODE
When operating in the AUTOMATIC scan mode it is possible to operate at a specific fre-
quency, which can be changed in case of interference or conflict with other radio systems,
using the “Changing the working frequency” procedure.
This mode allows to change the working frequency without internal interventions on the
transmitting unit or the receiving unit.
Changing the working frequency
a
b
1. With the transmitting unit start-
ed (blinking green LED):
- press the START pushbutton
and keep it pressed (a),
- press the STOP pushbutton (b),
- release the START pushbutton.
2. Unlock the STOP pushbutton
by turning it as shown in the pho-
to and repeat the starting proce-
dure.
N.B.: During the working fre-
quency changing process, the
receiving unit loses radio link
with the transmitting unit. After
starting, some seconds may
be necessary to reset connec-
tion, therefore keep the
START pushbutton pressed
for about 8-10 seconds.
To Next Page
Loading...
Need help?
General
