Page 4 2 - Introduction LILKNPA1-01 - AmEn.fm
Identification plates
The radio remote control identification and approval data is given on plates that are on both
the transmitting unit and the receiving unit.
These plates MUST NOT be:
- removed from their position
- altered or damaged (contact Autec for replacement)
2.2 GENERAL TECHNICAL DATA
Due to the characteristics of radio propagation (i.e.: EM interferences, near
out-of-range condition), a delay up to one second may occasionally occur be-
tween command release and actual deactivation of the corresponding output.
Care must be taken to ensure that this could never lead to a dangerous situa-
tion in the specific uses.
Frequency band...................................................................................... 902 - 928 MHz
Available radio channels............................................................................................ 32
Hamming distance .................................................................................................... ≥ 8
Probability of undetected error..................................................................... <10 exp-11
Typical working range............................................................................... 330 ft (100 m)
Command response time................................................................................ ~ 100 ms
STOP command response time....................................................................... ~ 100 ms
Passive emergency time (or passive stop)
*
................................................. 0.35/1 sec.
* refer to paragraph “Programming” in the receiving unit manual, DIP No. 1 settings.
To Next Page
Loading...
Need help?
General
