SWITCHING OFF
The transmitting unit should be switched off each time
work is stopped by extracting the starting keyswitch (al-
ways put the key in a safe place).
The transmitter unit may also switch off automatically if the
battery is not sufficiently charged and/or when the radio re-
mote control is not used for more than 3.5 minutes (refer to
paragraph 8 "Programming").
STOP
The STOP pushbutton should be pressed when it is necessary to stop the ma-
chine immediately when a dangerous condition should occur.
To stop the machine immediately, press the STOP pushbutton.
To start working again, after checking that the working conditions are safe, turn
the STOP pushbutton in the direction indicated to deactivate it and repeat the start-
ing procedure.
BATTERY
To recharge a low battery, proceed as
follows:
1. Insert the battery into its proper bat-
tery charger, which should be posi-
tioned in an area with a temperature
between +41°F and 113°F (+5°C and
+45°C): the battery now starts charg-
ing, a state signalled by the lighting up
of the “CHARGE” pilot light.
2. After a maximum of 4 hours the
“CHARGE” light switches off: the bat-
tery is fully charged. Remove the bat-
tery from the charger (if the battery is
not removed, the charger switches to
trickle charging).
LILKNPA1-01 - AmEn.fm 6 - Working mode of the LK transmitting unit Page 11
To Next Page
Loading...
Need help?
General
