auto maskin DCU 305 R2 User Manual

ii • 0BIntroduction - 4BImportant information
Rudolf R2 User's Manual
4.2.6 Switch type 24
4.2.7 Warning/Alarm/Shutdown on RUN only 25
4.2.8 Initial delay 25
4.2.9 Broken Wire Detection 25
4.2.10 Delay before alarm/shutdown 25
4.2.11 Additional Switch Inputs 26
4.3 Analog In 27
4.3.1 Add a new sensor 27
4.3.2 Active 28
4.3.3 Input Type 28
4.3.4 Description 28
4.3.5 Sensor Range 28
4.3.6 Units 28
4.3.7 Limit 28
4.3.8 Action Type 29
4.3.9 Double Scale 29
4.3.10 Above or below limit 30
4.3.11 Action on RUN only 30
4.3.12 Initial delay 30
4.3.13 Delay before Warning/Alarm/Shutdown 30
4.4 Standby operation 31
4.4.1 Initial Start Delay (Preheat timer) 31
4.4.2 Cranking Time 32
4.4.3 Delay between Start Attempts 32
4.4.4 Number of Start Attempts 32
4.4.5 Delay before disconnecting Gen. Breaker 32
4.4.6 Cooling time 32
4.5 Start/Fuel 33
4.5.1 Initial Start Delay 33
4.5.2 Cranking Time 33
4.6 Speed sensor 34
4.6.1 Pickup Information 34
4.6.2 Pickup One/Two RPM Sender 34
4.6.3 Ready to take Load 35
4.6.4 Nominal/Max Speed 35
4.6.5 Overspeed 35
4.6.6 RUN Detected At 36
4.6.7 Run Detection Delay 36
4.6.8 Additional RUN Detection 36
4.6.9 Speed Relays 36
4.7 Battery 37
4.7.1 Start Battery Voltage 37
4.7.2 Low Battery Voltage Alarm 37
4.7.3 Delay before Alarm 37
4.8 Info 38
4.8.1 Fields 38
4.9 Relays 39
4.9.1 RK-60 39
4.9.2 RK-66 R2 39
4.9.3 MK-6 and MK-14 39
4.9.4 Signals to the optional Relay Cards 40
4.9.5 Available configurable signals 41
4.9.6 Disable Broken Wire Alarm on Terminal 44 42

auto maskin DCU 305 R2 Specifications

General

Brand	auto maskin
Model	DCU 305 R2
Category	Control Unit
Language	English