Auto Meter BCT-468 - Page 34

34
This test will determine
whether the problem is
with the starter.
No Crank Situation
Press the Start
to begin the
test.
The BCT Tester will
prompt you to turn
and hold key. Press
OK while holding
key.
Note
: Voltage of 8V or greater at the
start enable input points to
trouble with the starter.
Otherwise there is trouble with
the start enable circuit.
Or whether the problem is the
the start enable circuit.
INDIVIDUAL TEST (Starter Test)
The BCT Tester will
show the user
how to connect
large red clamp
to starter positive.
Connect large
black clamp to
starter ground.
Connect small
red clamp to start
enable input.
Connect
small black clamp
to starter ground.