Auto Test autostop maxi

Questions and Answers

A
Ashley StevensJul 31, 2025
How to fix Auto Test autostop maxi Brake Meter that will not turn on?
- I
  Ivan NixonJul 31, 2025
  If your Auto Test Test Equipment Brake Meter won't turn on, there are a few potential reasons. First, the battery might be discharged; in this case, charge the battery for 12 to 16 hours. Alternatively, the battery charger itself may have failed, so check its output with a multimeter and inspect the condition of the fittings. Finally, the battery or internal electronics could be faulty, requiring you to return the unit for servicing.
J
jwrightAug 4, 2025
What to do if my Auto Test autostop maxi has no printout?
- R
  richard20Aug 4, 2025
  If your Auto Test Test Equipment is not printing, the most likely cause is that it's out of paper. To resolve this, remove the printer cover plate and check the paper roll.
C
Cesar WattsAug 8, 2025
Why does my Auto Test Test Equipment show “Time out“ on printout?
- T
  Theresa RamirezAug 8, 2025
  If “Time out“ is displayed on the Auto Test Test Equipment printout, it means the unit was not secured into position properly, or the foot has been lifted from the pedal before the vehicle stopped. Ensure the unit is correctly positioned and maintain foot pressure on the pedal until the vehicle comes to a complete stop.
N
noliverAug 13, 2025
What does “MEM FAILED” mean on my Auto Test Test Equipment Brake Meter?
- J
  James BakerAug 13, 2025
  If “MEM FAILED” is displayed when your Auto Test Test Equipment Brake Meter is switched on, this indicates that the internal flash memory is either not responding or is faulty. In this case, switch off the unit and return it for servicing.
T
Tony TorresAug 16, 2025
What does “Format Mem? Y/N” mean on Auto Test Test Equipment Brake Meter?
- J
  John OwensAug 16, 2025
  If “Format Mem? Y/N” is displayed when your Auto Test Test Equipment Brake Meter is switched on, it means that the internal flash memory is corrupt or unreadable. Press the ‘N’ key to skip formatting, then switch off the unit and return it for servicing.
H
hernandezdianeAug 21, 2025
What does “Reset All? Y/N” mean on Auto Test Test Equipment?
- D
  david94Aug 21, 2025
  If “Reset All? Y/N” is displayed when your Auto Test Test Equipment is switched on, it indicates that the clock memory is corrupt. Press ‘N’, switch off the unit, and return it for servicing.
L
laguirreAug 26, 2025
What does “Accelero Fail!” mean on Auto Test autostop maxi Test Equipment?
- E
  Erika OwensAug 26, 2025
  If “Accelero Fail!” is displayed when your Auto Test Test Equipment is switched on, it means that the accelerometer chip is faulty. Return the unit for servicing.