AutoStop Maxi User Manual Version 8.18 Page 10
Step 2: On your PC, click the Download test(s) button, then select the Com Port
to which the Brake Meter is connected and click Next.
Step 3: Enter the serial number of the Brake Meter. (Note that you must own a
license for the Brake Meter, and have entered the License Code in the
'Add License' section of this program - see below for more information).
Then click Next.
Step 4: Enter any comments for this test. These will be saved in the output file.
Then click Next.
Step 5: When you are ready, click the Next button to put the PC into Ready
mode. The PC display will read 'Turn on your Brake Meter now'.
Step 6: Turn on your Maxi Brake Meter. After displaying the product name,
serial number and revision, the display will read 'Connection..' while the
Brake Meter communicates with the PC. If the connection is successful,
the Brake Meter will display 'Data Logging...' while the data is uploaded
to the PC, then will switch itself off.
Step 7: After the data is downloaded and displayed on the screen, click the
'More Data' button to see the full test data, or select Print from the
toolbar to print the test and chart data to your printer.
Procedure for opening a previously saved log-file:
Step 1: Run the Maxi Data Logger software. Click the 'Open test(s)' button and
use the mouse to select one or more tests to open. If you hold down the
CTRL key you can select multiple tests.
Step 2: The log-files will be opened and the first test will be displayed on screen.
Use the buttons and the list at the top of the screen to view all the
different tests or print the data.
4. CHECKING SENSORS AND OTHER FUNCTIONS
With the Brake Meter in Ready mode, the battery voltage, deceleration, pedal force,
date and time can be checked. Note: None of these readings can be adjusted by
the operator.
To: Press Screen Display
Check battery life
“B”
Bat. life: xxx %
The Battery is considered flat when the percentage falls
below 85%
Check calibration
“C”
Cal: x.xx g Acceleration reading
To Next Page
Loading...