AutoStop Maxi User Manual Version 8.18 Page 5
are not present. However, if it is necessary to use another area, such as a public
road, only commence the test if no other vehicles are in the area and there is no
danger of an accident.
When the Brake Meter and the pedal sensor are both properly secured, turn the unit
on and follow the instructions in Section 3.6.
If an incorrect keystroke entry is pressed at any time, press the back-arrow key to
erase and then re-enter the correct keystrokes. The “beep” signal indicates the key
has been properly pressed and has registered on the display.
2.5 Special Characters
By using the following procedure you may obtain the following Special Characters:
To obtain the following characters, press and hold the “-“ key, then press the listed
character to obtain the special character.
Press “-“ and HOLD,
then Press:
Displayed Character Press “-“ and HOLD,
then Press:
Displayed Character
A ! N .
B “ O /
C # P (SPACE)
D $ Q !
E % R “
F & S #
G ‘ T $
H ( U %
I ) V &
J * W ‘
K + X (
L , Y )
M - Z *
To Next Page
Loading...