AutoStop Maxi User Manual Version 8.18 Page 11
(Toggle between
accelerometer &
pedal sensor
reading)
“C”
This should read close to 0.000 +/- 0.05 on a surface
measured as being horizontal and +/- 1.000 +/- 0.05
when vertical
Cal: xxx.x N Pedal Sensor reading - this should be within
20N of zero when no load is applied.
Check the date
“D”
Date: dd mmm yy
Check the time
“T”
Time: hh:mm:ss
Note: The internal clock can be changed from Local
Standard Time to Day Light Savings. After seeing “T” you
may toggle between Standard and Day Light time by
pressing “D”. Daylight Savings time is indicated with “*”.
Check printer feed
“P”
Paper advances until any key is pressed
Contrast on LCD
Display
“O”
BL= on or BL = Off Contrast X.
Backlight features are not standard (special order).
The Contrast may be changed by pressing “U” to go up
or “D” to go down. Pressing “E” will exit this function.
5. CALIBRATION PROCEDURE
The Brake Meter must be re-calibrated periodically. The reason for this is to
maintain creditability in tests and acceptance of data according to international
standards. Each time the unit is turned on, the LCD will show the date that the re-
calibration is due. The calibration due date is also shown on all printouts and upload
reports. At the time the unit is due for re-calibration, testing will not be possible. The
LCD screen will show: “Calibration due! Contact your vendor for recalibration.”
Return Brake Meter to AutoTest Products (See Section 6.1).
5.1 Return of AutoStop Maxi for Calibration
5.1.1 Packaging
The Brake Meter should be packaged in the original shipping container. However,
where this container is not available, remember that you are shipping an electronic
instrument. Bubble pack or foam should surround the Brake Tester and should be
inserted into a sturdy cardboard box.
Please ensure to return your charger for inspection also.
5.1.2 Shipping
Labelling - A label noting “Electronic Device - Fragile” should be placed on the box.
Freight Carrier - Container should be sent “Freight Prepaid”. AutoTest Products
has no preference on freight carriers. However, the unit should be forwarded by
companies such as WARDS, IPEC, UPS, or Federal Express if a expedient delivery
is required.
Ship to: The Service Department, AutoTest Products Pty Ltd, 279 Normanby Road,
Port Melbourne, VIC 3207, Australia. Phone: (+61 3) 9647 9707.
To Next Page
Loading...