AutoDab Connect - Other Remote Button Functions

AutoDAB Connect User Guide
10
P2
SCAN
Press
 Recall memory preset P2.
Press and Hold
 Program memory preset P2 while listening to a DAB station.
Function SCAN
 Perform a full scan for DAB stations.
P3
DAB
Press
 Recall memory preset P3.
Press and Hold
 Program memory preset P3 while listening to a DAB station.
Function DAB
 Set AutoDAB Connect to one of the 3 DAB preset modes to listen to DAB.
P4
MENU
Press
 Recall memory preset P4.
Press and Hold
 Program memory preset P4 while listening to a DAB station.
Function MENU
 87.6MHz – Default FM transmitting Frequency.
 RADIOTXT – enable/disable display of DLS/DL+ information from the station.
 LINKMODE – select operating mode (AFC_H/AFC_L/AutoScan).
 RC BEEP – enable/disable beep tone in response to remote control operation
 ANTENNA – set ON for using active DAB antennas, set OFF for using passive
antennas.
 DABRESET – erase the station list but keep the memory presets for all DAB
Presets, and then perform a full scan of DAB stations automatically after the DAB
has reset.
 FACTORY – return all system settings to defaults.
 UPGRADE – upgrade the module software to a new version.
 VERSION – display the current software version.
LINK
Press
 Display adaptor’s current FM transmitting frequency.
 Select and set the FM transmitting frequency from a manual setting or from one of
the four memory presets.
 Save the FM transmitting frequency setting to one of the four memory presets.
 In AutoScan mode, select and set the FM transmitting frequency from one of the
three AutoScan frequencies.
Press and Hold
 Perform an immediate FM transmitting frequency change.
BACK
Press
 Recall the last listened DAB station.
Press and Hold
 Reset FM transmitting frequency to the frequency saved in FM preset 1. Within 30
seconds, press and hold again to return the frequency to 87.6MHz.