AUTOHELM ST50 Wind Trim - 4. Maintenance; 4.1 Display units; 4.2 Cabling

4
ST50 WindTrim and SpeedTrim Operation and Installation Handbook
ST50 WindTrim and SpeedTrim Operation and Installation Handbook
4. Maintenance
4.1 Display units
13
• In certain conditions, condensation may appear on the window. This will
not harm the instrument, and can be cleared by switching on the
illumination to the brightest level.
• Never use any chemical or abrasive materials to clean your ST50 Trim
instrument. If the instrument becomes dirty wipe clean with a
damp cloth.
4.2 Cabling
• Avoid running cables through bilge's where possible and secure any
coiled lengths at regular intervals.
• Avoid running cables close to fluorescent lights,engines,radio
transmitting equipment etc.
• Check cabling for chafing or damage to outer casing, replace where
necessary and re-secure.
Advice
Should any difficulties arise, please consult Nautech's Product Support
department in the UK. or your own National Distributor who will be able to
provide expert assistance.