©
2007
Directed Electronics
15
Transmitter Configurations
The transmitters can be programmed with the standard or single button arm/disarm configurations
by using the Auto Learn functions in the Transmitter/Receiver Learn Routine.
Standard Configuration
A remote that uses the standard configuration operates similarly to many factory keyless entry
remotes. A standard configuration transmitter allows lock/arm, unlock/disarm, and Panic Mode
activation with separate buttons. When programmed for standard configuration using the Channel
1 Auto-learn configuration, the transmitter buttons are assigned to the following functions:
operates Lock/Arm only
operates Unlock/Disarm only
operates Channel 2 and Silent Mode
operates Panic only
and operate Channel 3
Master Dealer Remotes
A master dealer remote can be programmed into the system for demonstration purposes. Generally,
each salesman would carry a remote that would operate all the cars on the lot equipped with this
system. The dealer remotes(part# 465D) are binary transmitters that are detuned slightly in order
to limit transmitting range. The dealer remote can be taught to the system by following the
Transmitter Learn Routine. When installing the system, it is possible to preset all of the operation
settings using the master dealer remote. However, when the system is operated using the master
dealer remote, a special set of dealer default settings are followed. The dealer default settings are used
to ensure that every vehicle equipped with this system is protected at all times. Only the settings
listed below are affected. When using a master dealer remote, the system operates as follows:
➤➤
Passive arming
➤➤
Passive locking
➤➤
Panic, Valet, and passive arming bypass are disabled
➤➤
Security features on
To Next Page
Loading...
Need help?
General