TRANSMITTERS LIST MANAGEMENT
STEP 1 ACCESSING THE LIST
METHOD 1. GO TO START OF LIST
The list be be accessed by selecting the “Code Transmitter”
MENU (as in STEP 1 of the BASIC CODE TRANSMITTER
PROCEDURE), followed by pressing NEXT. This will display
the list with transmitter number 1 shown.
METHOD 2. GO TO A TRASMITTER’S LOCATION
WITHIN LIST
A particular transmitter’s location within the list can be displayed
by selecting the “Code Transmitter” MENU (as in STEP 1 of
the BASIC CODE TRANSMITTER PROCEDURE), followed
by pressing anyone of the transmitter’s buttons.
When the “Press Tx’er Again” message is displayed press NEXT
to display the transmitter’s location within the list. NOTE
“VIEW>” will not be shown if the transmitter is not stored.
20
THE CONTROLLER PROVIDES A TRANSMITTER LISTING FACILITY WHICH ENABLES THE USER TO FIND A
TRANSMITTER LOCATION WITHIN ITS MEMORY. ONCE LOCATED, A STORED TRANSMITTER CAN BE
REPLACED, DELETED, EDITED, COPIED OR, IF THE LOCATION IS EMPTY, A TRANSMITTER CODED INTO IT.
To Next Page
Loading...
