Automatic Technology Australia Pty Ltd to the extent that such may be lawfully excluded hereby expressly disclaims all
conditions or warranties, statutory or otherwise which may be implied by laws as conditions or warranties of purchase of an
Automatic Technology Australia Pty Ltd Sliding Gate Opener and Automatic Technology Australia Pty Ltd hereby
further expressly excludes all or any liability for any injury, damage, cost, expense or claim whatsoever suffered by any
person as a result whether directly or indirectly from failure to install the Automatic Technology Australia Sliding Gate
Opener in accordance with these installation instructions.
CONTENTS
PAGE CONTENTS
3 FEATURES
4 CONTROL BOARD LAYOUT
5 MENU STRUCTURE
6 INITIAL ELECTRICAL INSTALLATION
7 POWERING UP THE CONTROLLER
7 SETUP TRAVEL
7 LIMIT SWITCH / AMP TRAVEL SETUP
9 RE-PROFILING TRAVEL
10 SETTING TIMED TRAVEL
11 SETTING PEDESTRIAN POSITION
12 DESCRIPTION OF STANDARD OPERATION
13 CONTROL BOARD ADJUSTMENTS
13 MENU 2 CURRENT TRIPS
14 MENU 3 AUTO-CLOSE TIMES
14 MENU 4 LOCK TIMES
15 MENU 5 LIGHT TIMES
15 MENU 6 MOTOR SETTINGS
15 MENU 7 OPERATING MODES
17 PARAMETER VIEWING AND EDITING
18 TRANSMITTER OVERVIEW
18 BASIC CODE TRANSMITTER PROCEDURE
19 TRANSMITTER EDIT PROCEDURE
20 TRANSMITTER LIST MANAGEMENT
21 CODE OPERATION (LOCATION EMPTY)
21 CODE OPERATION (LOCATION USED)
21 DELETE OPERATION
21 EDIT OPERATION
21 COPY OPERATION
22 REMOTE CODE SET PROCEDURE
23 DIAGNOSTIC TOOLS (MENU 8)
23 MENU 8.1 TEST INPUTS
23 MENU 8.2 TEST TX’ERS
23 MENU 8.3 DISPLAY HISTORY
23 MENU 8.4 MEMORY USAGE
24 MENU 8.5 SERVICE COUNTER
24 MENU 8.6 COUNTERS
24 MEMORY TOOLS (MENU 9)
24 MENU 9.1 CLR CONTROL
24 MENU 9.2 CLR TX’ERS
25 SPECIFICATIONS
26 WARRANTY AND EXCLUSION OF LIABILITY
To Next Page
Loading...
