Automatic Technology SecuraLift Rhino - Page 29

Installation Instructions & Owner’s Manual SecuraLift® Rhino 29
Parameters
BUTTON FUNCTIONS
Button Function
OPERATE Opens/stops/closes the door
CODE SET Codes a transmitter button for operate function
FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting
FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting
FORCE MARGIN SET (then) LIMIT
SET
Reloads the factory set default obstruction force margin setting
LIMIT SET (for 6 seconds) Clears the door limits set positions. Limits then need to be reset
LIMIT SET (the power on) and hold
until all LEDs are off
Deletes control parameters excluding transmitter storage memory
CODE SET press and hold until
DOOR CODE LED starts fl ashing
Deletes all transmitter storage memory
LIMIT SET & CODE SET (the power
on) and hold until all LEDs are off
Deletes all control parameters and transmitter storage memory