Automatic Technology SecuraLift Rhino - Page 5

Installation Instructions & Owner’s Manual SecuraLift® Rhino 5
The garage door must be well balanced. Sticking or binding doors must be repaired by a qualifi ed garage door
installer prior to installation of the SecuraLift® Rhino Overhead Garage Door Opener.
Frequently examine the installation, in particular cables, springs and mountings for signs of wear, damage or
imbalance. DO NOT use if repair or adjustment is needed since a fault in the installation or an incorrectly
balanced door may cause injury. DO NOT attempt to repair the door yourself as hardware is under extreme
tension.
Remove or disengage all garage door locks and mechanisms prior to installation of
the opener.
Connect the SecuraLift® Rhino Overhead Garage Door Opener to a properly earthed general
purpose 240V mains power outlet installed by a qualifi ed electrical contractor.
Disconnect the power cord from mains power before making any repairs or removing
covers. Only experienced service personnel should remove covers from the SecuraLift®
Rhino Overhead Garage Door Opener.
When using auto-close mode, a P.E. Beam must be fi tted correctly and tested for
operation at regular intervals. Extreme caution is recommended when using auto-
close mode. All safety rules must be followed - see page 24 for full details.
In order for the SecuraLift® Rhino Overhead Garage Door Opener to sense an
object obstructing the doorway, some force must be exerted. As a result the
object, door and/or person may suffer damage or injury.
If the power supply cord is damaged, it must be replaced by an Automatic
Technology service agent.
Make sure that the door is fully open before driving in or out of the
garage and fully closed before leaving the driveway.
Make sure that remote controls are kept out of reach of
children.
Install the wall mounted transmitter in a location where it is
out of reach of children and the garage door is visible.