To Next Page

To Previous Page

Setting Timer Parameters

To enter the page for parameter setting of the timer, press

in the main menu for more than 3 seconds. After the

setup is complete, press

for more than 3 seconds under any of the paramter page you are in and return to the

main menu.

–funC

time Cont taCH –mix

t–mode

–up down

t–otmd

sond1 sond2 soffd –son

pond

t–out1

–002 –000

pondh

–rCy rCyh rCy2 sConstonstoff

Select funtions: There are 4 modes in CTT, (left to right) timer, counter, tachometer and timer + counter.

Select timer mode: timing up and timing down

t–unit

s–001 s–01 –s–1 ms–001

ms–01m–01

–m–1 hms–1 hm–1–h–1

Select output modes: There are 12 output modes in the timer. The user can choose the mode that best

meets the demand.

Select display unit: the min. unit 10ms to the max. unit hour are selectable.

Select pulse width of output 1: The default output time is 0.02 second. When the parameter is set to 0.00

second, the output status will be maintained ON.

–rtsr

––20 –––1

Select min. width of reset signal: The defaul value is 20ms; can be set to 1ms.

inptlC

–npn –pnp

Select input signal types: NPN and PNP.

or or

or or or

or or

or or or or

or or

orororororor

or or or or

6-6

1-800-633-0405

Digital Counter / Timer / Tach User Manual, 1st Ed.

Brand	Automation Direct
Model	CTT-1C-A120
Category	Timer
Language	English

Automation Direct CTT-1C-A120 User Manual

Table of Contents

Questions and Answers:

Automation Direct CTT-1C-A120 Specifications

Related product manuals