Instruction Manual QNix
®
8500
- 13 -
8.3.5.3 Batch Information
The menu item "Info" displays date and time of the batches creation as well as the number of
readings in the batch.
8.3.5.4 Limits
Selecting “Upper Limit” or “Lower Limit” will display all the limits for this batch. If no batch lim-
its have been set, the last reading will be displayed.
Set upper and lower limits for each individual batch with this menu item as described in
§§ 8.2.3 and 8.2.4.
The modified limit values for the active batch are used instead of global limits.
8.3.5.5 Rename a Batch
After accessing this menu item follow the instructions given in § 8.3.4 to rename a batch.
8.3.5.6 Deleting the values in a Batch
By selecting this menu item you can delete the readings in a batch without deleting the batch
itself. Thus the name and creation date of the batch as well as the sequence of batches will
be preserved.
8.3.5.7 Delete a Batch
After accessing this menu item, press the ►button to delete the entire batch including its
content.
8.4 Statistics
The statistics functions are calculated per memory block.
The gauge determines the following statistical parameters:
- average value
- standard deviation
- maximum
- minimum
Within the statistics menu, two different forms of display are available:
a) You can choose two statistical parameters of the active batch to be displayed in
parallel to the readings. These parameters are constantly updated when adding
new readings.
b) You can display all statistical data of a batch in an informational window.
Selecting the menu item “Statistics” displays the batch list.
8.4.1 Selecting the Statistical Parameters to be displayed in an active
batch
If a memory block is currently active, it is marked with a dot. Selecting the active batch and
then pressing the ► button displays a submenu where you can choose to show all statistical
data of the batch, or to select parameters for online statistics.
Selecting “Select” opens the list of statistical parameters. Select the desired parameters us-
ing the ▲and ▼buttons and activate or deactivate them by pressing ►.
NOTE: A maximum of 2 parameters can be activated at the same time!
To leave this menu item press the backspace button ◄. To directly return to display mode,
shortly press the measuring head.
To Next Page
Loading...
Need help?
General
