Automation Dr. Nix QNix 8500 - 15 Updating the Software in the Gauge and Probe; 16 Display Symbols

Instruction Manual QNix
®
8500
- 18 -
16 Display Symbols
 Fe measurements on iron- and steel surfaces (-substrates)
 NFe measurements on non-iron metallic surfaces
 Error operating error
 Infi readings outside measuring range, wrong type of surface
 ^ readings exceeding upper limit
 ˇ readings below lower limit

x
average
 σ standard deviation
 Ψ wireless interface active
 Ψ
p
radio controlled probe switched on, radio controlled probe active
 continuous measuring mode
 buzzer switched off
 low battery, keep new ones ready
 empty battery