Automationdirect.com SOLO Basic - Reset to Factory Default; Key Lock Function

Chapter 3: Keypad Operation and Setup Parameters
SOLO Basic Temperature Controller User Manual
3–14
al2d
Alarm 2 Delay
Length of time alarm condition must be active in seconds before alarm
condition is triggered.
Reset to Factory Default
Note: Resetting the Temperature Controller back to factory default erases all of the
values entered by the user. Record any necessary settings before proceeding
Warning: Erasing the user entered values may result in a safety hazard and system
malfunction.
The following instructions reset the controller to the factory default.
1 Press the
'
button until the parameter
loC
appears. Use the
.
button
to select
loC1
. Press the
;
button.
2 Press and hold the
;
and
.
buttons simultaneously for three seconds
and release.
3 Use the
.
button to change the value on the SV display to
1357
. Press
the
;
button.
 Display will change from PASS to PArE. Press
.
to change value from no
to yes and press set button.
 Display will be fully lit and then controller will reboot.
Key Lock Function
Adjusting paramber of LoC to LoC1 in Operation Mode to lock all keys. LoC2
allows the SV value to be adjusted.
To unlock:
1 Press the ;
‘
and • keys simultaneously in LOCK mode to display KEYP.
Enter the password to unlock the key. Default password is 0000.
To change key lock password:
1 Press the
'
key when KEYP is displayed to enter the password change
screen CH6P.
2 Enter the current password. If the password is correct, nEwP will be
displayed. If the password is incorrect, the screen will return to PV/SV
display mode.