AutomationDirect DURAPULSE GS3-43P0 - Page 124

Chapter 4: AC Drive Parameters
4–56
 Multi-Speed 1
Default Setting: 0.0
 Multi-Speed 2
Default Setting: 0.0
 Multi-Speed 3
Default Setting: 0.0
 Multi-Speed 4
Default Setting: 0.0
 Multi-Speed 5
Default Setting: 0.0
 Multi-Speed 6
Default Setting: 0.0
 Multi-Speed 7
Default Setting: 0.0
 Multi-Speed 8
Default Setting: 0.0
 Multi-Speed 9
Default Setting: 0.0
 Multi-Speed 10
Default Setting: 0.0
 Multi-Speed 11
Default Setting: 0.0
 Multi-Speed 12
Default Setting: 0.0
 Multi-Speed 13
Default Setting: 0.0
 Multi-Speed 14
Default Setting: 0.0
 Multi-Speed 15
Default Setting: 0.0
Range for P5.01~P5.15: 0.0 to 400.0 Hz
The Multi-Function Input Terminals (refer to P3.02 to P3.10) are used to select one
of the AC drive preset Multi-speeds. The speeds (frequencies) are determined by
the settings of P5.01 to P5.15.
Multi-Speed Bits
Speed Selection
Bit 4 Bit 3 Bit 2 Bit 1
OFF OFF OFF OFF
P4.00: Source of
Frequency
OFF OFF OFF
ON
P5.01: Multi-Speed 1
OFF OFF
ON
OFF P5.02: Multi-Speed 2
OFF OFF
ON ON
P5.03: Multi-Speed 3
OFF
ON
OFF OFF P5.04: Multi-Speed 4
OFF
ON
OFF
ON
P5.05: Multi-Speed 5
OFF
ON ON
OFF P5.06: Multi-Speed 6
OFF
ON ON ON
P5.07: Multi-Speed 7
Multi-Speed Bits
Speed Selection
Bit 4 Bit 3 Bit 2 Bit 1
ON
OFF OFF OFF P5.08: Multi-Speed 8
ON
OFF OFF
ON
P5.09: Multi-Speed 9
ON
OFF
ON
OFF P5.10: Multi-Speed 10
ON
OFF
ON ON
P5.11: Multi-Speed 11
ON ON
OFF OFF P5.12: Multi-Speed 12
ON ON
OFF
ON
P5.13: Multi-Speed 13
ON ON ON
OFF P5.14: Multi-Speed 14
ON ON ON ON
P5.15: Multi-Speed 15
When all multi-speed inputs are off, the AC drive reverts back to the Command
Frequency (P4.00).
P5.15
P5.14
P5.13
P5.12
P5.11
P5.10
P5.09
P5.08
P5.07
P5.06
P5.05
P5.04
P5.03
P5.02
P5.01
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013