AutomationDirect DURAPULSE GS3-43P0 - DURA PULSE Parameter Memory Addresses

Chapter 5: DURAPULSE MODBUS Communications
5–4
DURAPULSE Parameter Memory Addresses
Parameter Memory Addresses
Parameter Description Hexadecimal
Modbus
Decimal *
Octal
Motor Parameters
P0.00
Motor Nameplate Voltage 0000 40001 0
P0.01
Motor Nameplate Amps 0001 40002 1
P0.02
Motor Base Frequency 0002 40003 2
P0.03
Motor Base RPM 0003 40004 3
P0.04
Motor Maximum RPM 0004 40005 4
P0.05
Motor Auto Tune 0005 40006 5
P0.06
Motor Line to Line Resistance R1 0006 40007 6
P0.07
Motor No-Load Current 0007 40008 7
Ramp Parameters
P1.00
Stop Methods 0100 40257 400
 P1.01
Acceleration Time 1 0101 40258 401
 P1.02
Deceleration Time 1 0102 40259 402
P1.03
Accel S-curve 0103 40260 403
P1.04
Decel S-curve 0104 40261 404
 P1.05
Acceleration Time 2 0105 40262 405
 P1.06
Deceleration Time 2 0106 40263 406
P1.07
Select method to use - 2nd Accel/Decel 0107 40264 407
P1.08
Accel 1 to Accel 2 frequency transition 0108 40265 410
P1.09
Decel 2 to Decel 1 frequency transition 0109 40266 411
P1.10
Skip Frequency 1 010A 40267 412
P1.11
Skip Frequency 2 010B 40268 413
P1.12
Skip Frequency 3 010C 40269 414
P1.13
Skip Frequency 4 010D 40270 415
P1.14
Skip Frequency 5 010E 40271 416
P1.17
Skip Frequency Band 0111 40274 421
P1.18
DC Injection Current Level 0112 40275 422
P1.20
DC Injection during Start-up 0114 40277 424
P1.21
DC Injection during Stopping 0115 40278 425
P1.22
Start-point for DC Injection 0116 40279 426
* For Modbus Decimal addresses used with CLICK PLCs,
insert another zero as the next-to-most-significant digit, e.g., 402333 instead of 42333.
 Parameter can be set during RUN Mode.
The octal address also can be used in the WX / RX instruction of the DL-250-1, DL-450,
and DL05.
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013