3–5
Programming the DURAPULSE AC Drive
The DURAPULSE AC Drive parameters are organized into eleven (11) different groups
according to their functions, plus a special “Copy Keypad” function for storing up to
four (4) different sets of program parameters into the keypad. The illustration below
shows you how to navigate through the parameter groups and parameter settings. For
a complete list of parameters, see C
HAPTER 4.
Press the PROGRAM key and then use the UP/DOWN or
PROGRAM keys to cycle through the parameter groups. The LCD
display will show the parameter group that is currently selected.
Press the ENTER key to display the various parameters for the
selected group and use the UP/DOWN keys to view each one.
When the desired parameter is shown, press the ENTER key to
select.
Use the UP/DOWN keys to cycle through the available settings.
Press the ENTER key to select the
setting. The phrase “Value
Accepted” will be displayed for a
moment to show that the
parameter value has been
changed.
After the parameter value has been
set, the LCD display will cycle to
the next parameter in the selected
group.
Chapter 3: Keypad Operation and Quickstart
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013
To Next Page
Loading...