Autonics CX6M-1P Series - Page 83

6 Timer mode
© Copyright Reserved Autonics Co., Ltd. 83
(7) When SET1 is greater than SET2
In case of OND[OND], OND.1[ONd1], OND.2[ONd2] , or OND.3[ONd3] output mode,
 UP mode: When timer setting value 1 (SET1) is greater than setting value 2 (SET2),
OUT1 output does not turn ON.
 DOWN mode: When timer setting value 1 (SET1) is greater than setting value 2 (SET2),
OUT1 oututput does not turn ON. When timer setting value 1 (SET1) and setting value
2 (SET2) are same, OUT1 output turns ON when applied the start signal.
1) Output mode: OND (Signal On Delay)
2) Output mode: ONd1 (Signal ON Delay 1)