Autonics SPR Series User Manual

Safety Considerations
© Copyright Reserved Autonics Co., Ltd. vii
Safety Considerations
 Following these safety considerations will ensure the safe and proper use of the product
and help prevent accidents, as well as minimizing possible hazards.
 Safety considerations are categorized as Warnings and Cautions, as defined below:
Warning
Failure to follow the instructions may lead to a serious injury
or accident.
Caution
Failure to follow the instructions may lead to a minor injury
or accident.
 Fail-safe device must be installed when using the unit with machinery that may cause
serious injury or substantial economic loss. (e.g. nuclear power control, medical equipment,
ships, vehicles, railways, aircraft, combustion apparatus, safety equipment, crime/disaster
prevention devices, etc.)
Failure to follow this instruction may result in fire, personal injury, or economic loss.
 Install on the device panel, and ground to the heat sink or bracket separately.
Failure to follow this instruction may result in electric shock or fire.
 Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in electric shock or fire.
 Check 'Connections' before wiring.
Failure to follow this instruction may result in fire.
 Do not disassemble or modify the unit.
Failure to follow this instruction may result in electric shock or fire.
 Use the unit within the rated specifications.
Failure to follow this instruction may result in fire or product damage.
 Use dry cloth to clean the unit, and do not use water or organic solvent.
Failure to follow this instruction may result in electric shock or fire.
 Do not use the unit in the place where flammable/explosive/corrosive gas, humidity, direct
sunlight, radiant heat, vibration, impact, or salinity may be present.
Failure to follow this instruction may result in fire or explosion.
 Keep metal chip, dust, and wire residue from flowing into the unit.
Failure to follow this instruction may result in fire or product damage.
 Since leakage current still flows right after turning off the power or in the output OFF status,
do not touch the load terminal.
Failure to follow this instruction may result in electric shock.
The specifications of communication manual are subject to change and some models
may be discontinued without notice.

Autonics SPR Series Specifications

General

Brand	Autonics
Model	SPR Series
Category	Controller
Language	English