8
NOTE
During the cleaning process, you can hear the intermittent
vibration when you take the fuel injector out and put it near
your ear, which can determine whether the injector has a pulse
signal.
Before the injector detergent is added into the ultrasonic clean-
er, do not turn on the ultrasonic cleaner. Otherwise, damage
may be incurred.
Only the ultrasonic cleaning liquid matched with the machine
can be added to the ultrasonic tank, and other cleaning liquid
can not be used instead, otherwise, the surface coating of the
equipment and the mask will peel off, which will not be covered
by the warranty.
Press the item selection up and down keys to select the “01
Ultrasonic Cleaning” item, and then press the working time up
and down keys to set the time. (The system defaults to 10
minutes, if you need to modify the time, you can change it with
the up and down keys)
Press the run key, and the system starts to input pulse signals.
When finished cleaning, take out the injectors from the
ultrasonic tank. Wipe off the cleaning liquid with a soft cloth
and prepare for the next operation.
●
●
Test
functions
This function is to detect the sprayability, dripping, blockage, fuel
injecting angle of the fuel injectors and the amount and uniformity
of the fuel injection of each fuel injector at different RPM.
Preparation
Add test liquid. Pour the test liquid from the filling port.
Installation of fuel injectors.
●
●
To Next Page
Loading...
Need help?
General
