17
4.8 EVAP System Test
Select On-board Monitoring in Diagnostic Menu and press ENTER
and the screen will display as shown below (Data will be different
everytime):
The EVAP test function lets you initiate a leak test for the vehicle's
EVAP system. The CReaderVI does not perform the leak test, but
signals to vehicle's on-board Computer to initiate the test. Before
using the system test function, refer To The vehicle's service repair
manual to determine the procedures necessary to stop the test.
You can use UP or DOWN button to select an item and press ENTER,
the screen will display as shown below (Data will be different
everytime):
Press EXIT to return to Diagnostic Menu.
EN
To Next Page
Loading...
