Page - 26
"Lo saLt" message is displayed / Salt LED is solid red
Problem
The salt level is between 2,300-2,700 ppm (mg/L), which is low.
Typical Solution
This message will appear when salt is between 2,300 - 2,700 ppm (mg/L). Test the salt level
using salt test strips or have water tested by your local pool professional. Bring the salt level up
to 3,500 ppm (mg/L).
When paired with the PoolSync
TM
option, consult the PoolSync
TM
app for more information.
"Add SaLt" message is displayed / Salt LED is flashing red
Problem
Chlorine generation has stopped because the salt level is below 2,300 ppm (mg/L), which is too
low.
Typical Solution
Test the salt ppm level using salt test strips or have water tested by your local pool professional.
Bring the salt level up to 3,500 ppm (mg/L).
When paired with the PoolSync
TM
option, consult the PoolSync
TM
app for more information.
Cell LED is flashing red. Display shows "CELL"
Problem
The cell is dirty or may have calcium build up.
Typical Solution
Inspect and clean as appropriate. See "Cleaning the Cell" on page 17.
Problem
Salt level may be low. Check the salt indicator LED and display for possible error messages.
Problem
Pool/spa water chemistry may not be balanced. See "Water Balance and Chemistry
Recommendations" on page 9 .
Typical Solution
Contact your local pool professional and take necessary steps to balance the body of water.
Note: The cell LED may also flash red if salt has been added to the pool water recently. Wait 24
hours for salt to be completely diluted.
To Next Page
Loading...
Need help?
General
