Autostacker™ Parking Lift 59 P/N 5900248 — Rev. B — May 2021
Contacting the Electrician
As mentioned previously, there are installation tasks that
require
a licensed, certified Electrician.
⚠ DANGER All wiring
must
be performed by a licensed, certified Electrician. If someone who is
not a certified Electrician attempts these tasks, they could damage the Lift or be
electrocuted, resulting in serious injury or even death.
The Electrician needs to:
• Connect a power source to the Master Power Unit. A power source is required. The
Power Unit comes with a pigtail for wiring to a power source. Have your Electrician connect a
power cord with plug on the electrical box on the Lift (for connection to a power outlet) or have
them wire it directly into the electrical system at the Lift location.
• Connect the Control Stands to the MPU. A power source is required.
• Install a Power Disconnect Switch. Ensures you can quickly and completely interrupt
electrical power to the Lift in the event of an electrical circuit fault, emergency situation, or when
equipment is undergoing service or maintenance.
• Install a Thermal Disconnect Switch. Ensures the equipment shuts down in the event of an
overload or an overheated motor.
The Electrician is responsible for providing:
• an appropriate plug to attach to the Power Unit
• an appropriate Power Cord that goes from the power source to the plug on the Power Unit
Important electrical information:
– 220 VAC, 60 Hz, single phase, 5 HP requires a minimum 8 AWG wire
– 208-230 VAC, 50/60 Hz, three phase, 10 HP requires a minimum 8 AWG wire
– 460 VAC, 60 Hz, three phase, 10 HP requires a minimum 10 AWG wire
⚠ DANGER Risk of explosion: This equipment has internal arcing or parts that may spark and
should not be exposed to flammable vapors. The Power Unit’s motor should not be
located in a recessed area or below floor level. Never expose the motor to rain or
other damp environments; damage to the motor caused by water is
not
covered
by the warranty.
To Next Page
Loading...