Panel Description
System Description, Autroprime Interactive Fire Detection System, 116-P-APRIME-SYSTEMD/XGB 2007-10-10,
Autronica Fire and Security AS
Page 20
3.6 Mimic Driver BUR-200
The BUR-200 is a Mimic Driver that is capable of driving 32 LEDs with series
resistors on a mimic panel for additional indication of alarms. In addition, 8
standard monitored inputs can be used for reading various switches.
The Mimic Driver is connected to the RS-485 Panel Bus.
Power redundancy is achieved by using a daisy-chain connection with
master and slave drivers.
3.7 “Larmlagringspanel” BU-211
The ”Larmlagringspanel” BU-211 allows control of fire alarms from a
Detection Zone or a small collection of Detection Zones.
Only alarms from Detection Zones within the scope of a specific
”Larmlagringspanel” will be shown in the display.
The Fire Alarm Control Panel in an Autroprime system can be configured to
operate with small local alarm areas which allows the system to function in a
delayed coincidence alarm mode (based on two timers T1 and T2). This
gives a local user to the ”Larmlagringspanel” time to investigate a warning
before either cancelling the possible alarm condition (if a false alarm) or to
allow the user to set the system into alarm (if there is a real fire).
To Next Page
Loading...