User Manual
12/2024
4
www.AvantcoRefrigeration.com
Installation
This unit is intended for use in a temperature-controlled environment of less than 75°F and 60%
relative humidity.
Before Installation
•
If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet
to promote proper airflow. Failure to install the shelves properly is considered user error and is not
covered by warranty.
•
If the unit has recently been transported on its side, please let unit stand upright for a minimum of
24 hours before plugging it in.
•
Make sure that the unit has reached the desired temperature before loading the unit with
products. This unit is meant for keeping cold products cold, not chilling warm products.
•
Make sure that there is proper ventilation around the unit in the area where it will operate.
•
Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging in the
unit.
•
Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing/repair.
•
Do not hang on doors or stand inside the unit.
•
Please read through the manual in its entirety.
Cabinet Location Guidelines
• Install the unit on a strong and leveled surface.
• If the surface is uneven, the unit may be noisy.
• The unit may malfunction if the surface is uneven.
• Install the unit in an indoor, well-ventilated area.
• For best performance, please maintain clearance of 4" on the back of the unit.
• Brackets should be attached on the back of the unit.
• Do not use outdoors. For indoor use only.
• Avoid direct sunlight.
• Avoid installation in a high humidity and/or dusty area.
• Humidity above 60% can cause the unit to rust, collect condensation, and may
decrease eciency.
• Dust collected on condenser coil will cause unit to malfunction.
• Select a location away from heat and moisture-generating equipment.
• Ambient temperatures above 75°F may cause the compressor to malfunction.
• For optimal performance, this unit should not be used in environments with ambient
temperatures exceeding 75°F.
• The unit should not be placed in areas with an ambient temperature over 90°F.
• Equipment malfunctions due to ambient temperatures above 90°F could void the warranty.
• Do not install this unit inside a closet or alcove.
• For optimal performance, 3" of clearance is required around all louvered or vented panels to allow for
proper airflow.
• For your convenience, a set of brackets is included to prevent this unit from being pushed up
against a wall.
• Component failure due to improper installation is not covered under warranty.
To Next Page
Loading...
