To Next PageTo Next Page
Need help?Do you have a question about the Avantco 178APT27HC and is the answer not in the manual?
Steps to navigate and save controller parameters for temperature management.
Explanation of the password setting parameter for the controller, range 0-200.
How to select between Celsius and Fahrenheit for temperature display.
Adjusting temperature offset for the cabinet.
Adjusting temperature offset for the evaporator.
Setting the temperature differential for the controller, range 0-19°F.
Setting the lowest allowed temperature for the unit, range -50°F to r2.
Setting the highest allowed temperature for the unit, range r1 to 200°F.
Setting the delay before compressor and fan start, range 0-100 minutes.
Configuring the interval between defrost cycles, range 0-199 hours.
Setting the temperature point to end a defrost cycle, range -50°F to 130°F.
Setting the maximum duration for a defrost cycle, range 1-199 minutes.
Procedures for testing compressor and capacitor components for proper function.
Steps to test the unit's electronic controller for voltage and connection integrity.
How to test the evaporator fan motor for proper operation and current draw.
Procedure for testing the condenser fan motor for voltage and current draw.
Methods for testing the door seal heater element for resistance and voltage.
Step-by-step guide for removing and replacing the temperature controller.
Instructions for safely removing and replacing the unit's compressor.
Procedure for safely replacing the compressor's start/run capacitor.
Steps to safely replace the refrigerant filter drier.
Guide for removing and replacing the condenser fan cover.
Instructions on how to replace the condenser fan blade.
Procedure for replacing the condenser fan motor.
Steps to safely remove and replace the condenser coil assembly.
Guide for safely removing and replacing the evaporator fan motor.
Instructions for safely removing and replacing the evaporator coil.
Steps to navigate and save controller parameters for temperature management.
Explanation of the password setting parameter for the controller, range 0-200.
How to select between Celsius and Fahrenheit for temperature display.
Adjusting temperature offset for the cabinet.
Adjusting temperature offset for the evaporator.
Setting the temperature differential for the controller, range 0-19°F.
Setting the lowest allowed temperature for the unit, range -50°F to r2.
Setting the highest allowed temperature for the unit, range r1 to 200°F.
Setting the delay before compressor and fan start, range 0-100 minutes.
Configuring the interval between defrost cycles, range 0-199 hours.
Setting the temperature point to end a defrost cycle, range -50°F to 130°F.
Setting the maximum duration for a defrost cycle, range 1-199 minutes.
Procedures for testing compressor and capacitor components for proper function.
Steps to test the unit's electronic controller for voltage and connection integrity.
How to test the evaporator fan motor for proper operation and current draw.
Procedure for testing the condenser fan motor for voltage and current draw.
Methods for testing the door seal heater element for resistance and voltage.
Step-by-step guide for removing and replacing the temperature controller.
Instructions for safely removing and replacing the unit's compressor.
Procedure for safely replacing the compressor's start/run capacitor.
Steps to safely replace the refrigerant filter drier.
Guide for removing and replacing the condenser fan cover.
Instructions on how to replace the condenser fan blade.
Procedure for replacing the condenser fan motor.
Steps to safely remove and replace the condenser coil assembly.
Guide for safely removing and replacing the evaporator fan motor.
Instructions for safely removing and replacing the evaporator coil.
General| Brand | Avantco |
|---|---|
| Model | 178APT27HC |
| Category | Refrigerator |
| Language | English |
