User Manual
12/2024
5
www.AvantcoRefrigeration.com
Electrical
•
Ensure that the required voltage is being supplied at all times.
•
The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate
over-current protection. Refer to the electrical requirements on the unit's nameplate.
•
The unit should have its own dedicated outlet.
•
DO NOT use extension cords.
•
Ensure the unit is not resting on or against the electrical cord.
•
If the unit is not in use for a long period of time, unplug from the outlet.
•
To avoid shock and fire hazards, DO NOT plug in or unplug the unit with wet hands.
•
After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so
could cause damage to the compressor.
Temperature Controls
•
Refrigerant LED - Compressor is on.
•
Fan LED - Fan is on.
•
Defrost LED - Defrost cycle is running.
•
Your new refrigerator is already factory set to run at optimum temperatures for food safety and
should require no adjustments.
•
Refrigerators are set to cycle between a minimum temperature of 33°F and a maximum
temperature of 40°F.
•
Adjusting the temperature changes the minimum temperature at which your unit will run. Your unit
will not run constantly at this setting. To change it, follow these instructions:
Digital Control Units
1.
Hold “SET” for 1 second. The display will flash the
current minimum temperature.
2.
Use the arrow buttons to adjust the minimum
temperature.
3.
Press “SET” again to save your settings.
•
Always remember to calculate the dierential if you
change the minimum temperature setting.
The cabinet temperature will fluctuate up to 7°F
over your set minimum temperature as the
compressor runs and shuts o. Setting the
temperature too high will result in unsafe maximum
temperatures and possible health code violations.
Adjusting the Temperature
Refrigerator
To Next Page
Loading...
