b. Pull the blue latches on the chassis rails towards the front and slide the switch into the
frame.
Note:
After you install the switch in a rack, slide it out until the lock (shown above) engages.
To slide the switch back into the rack, push the blue release latches on the chassis rails
towards the back and slide the switch into the frame.
8. Connect power and network connections to the switch.
Installing the VSP 8000 Series in an equipment rack
November 2016 Installing the Avaya VSP 8000 Series 51
Comments on this document? infodev@avaya.com
To Next Page
Loading...
