RJ45 port LED state indicators
This section describes the port LED state indicators by number, color and fluctuation cues.
100/1G/10G RJ45 port LED state indicators
The RJ45 ports used in the system have single LED labelled as “Link/Activity”. The following table
shows the status of the one LED:
Table 18: 100/1G/10G RJ45 port LED state indicators
Label Color and Status Description
Link/Activity Off The port does not have link.
Blue (solid) The port has link in 10Gbps mode.
Blue (blinking) The port has link and data activity
in 10Gbps mode.
Amber (solid) The port has link in 100Mbps
mode.
Amber (blinking) The port has link and data activity
in 100Mbps mode.
Green (solid) The port has link in 1Gbps mode.
Green (blinking) The port has link and data activity
in 1Gbps mode.
Green (slow blinking) The port is administratively
disabled.
10/100/1000 RJ45 port LED state indicators
The 10/100/1000 RJ45 ports used in the system have two LEDs. Each LED is located on either side
of the RJ45 tab. The right LED is labeled as “Speed” and the left LED is labeled as “Link/Activity”.
The following table shows the status of the two LEDs:
Table 19: 10/100/1000 RJ45 port LED state indicators
Label Color and Status Description
Speed Off The port is operating at 10Mbps
mode.
Amber (solid) The port is operating at 100Mbps
mode.
Green (solid) The port is operating at 1Gbps.
Link/Activity Green (solid) The port has link and there is no
data activity.
Green (blinking) The port has link and there is data
activity.
Table continues…
LED state definitions
November 2016 Installing the Avaya VSP 8000 Series 85
Comments on this document? infodev@avaya.com
To Next Page
Loading...
