8. Use the countersink screws with the following steps to attach the extension bracket to the
rack rail:
a. Push the blue release lock up and slide the middle rail out as far as possible.
b. Note the order and position of how the components are installed. The extension bracket
(with the flat side down) goes on top of the rack rail and then the long rear bracket
slides into the extension bracket.
c. Orient the extension bracket over the holes in the rack rail.
Installing the Avaya Virtual Services Platform 8000 Series
November 2016 Installing the Avaya VSP 8000 Series 58
Comments on this document? infodev@avaya.com
To Next Page
Loading...
