Avaya C360 - Monitoring; Power over Ethernet (PoE) Support

Power Up
24 Quick Start for Hardware Installation: The Avaya C360 Converged Stackable Switch
!
WARNING:
!
WARNING: Make sure that you connect the cables between the C360 and the external power
supply correctly:
● Positive (“+”) to positive (“+”)
● Negative (“-“) to negative (“-“)
!
WARNING:
!
ADVERTENCIA: Asegúrese que las polaridades de los cables entre el C360 y la fuente de
alimentación externa estén conectados correctamente:
● Positivo ("+") a Positivo ("+")
● Negativo ("-") a Negativo ("-")
3. Replace the plastic cover by aligning the holes with the screw receptacles and replacing
the two Phillips screws.
Supplemental Earthing of the C360 (Optional)
When connecting a BUPS to the C360, you must also connect a ground wire to the ground stud
provided on the rear of the unit. This ground conductor must be green/yellow, a minimum of 16
AWG and be terminated with a lug that is suitable for the M4 stud provided. The other end of the
ground conductor is to be terminated to a suitable building ground point such as a cold water
pipe.
Post-Installation
The following indicate that you have performed the installation procedure correctly:
Table 6: Post-Installation Indications
Procedure Indication
Powering the C360
● All front panel function LEDs illuminate briefly.
- If the PWR LED blinks once every 1
second, then the BUPS is active and the
main PSU is down.
● The LINK, SYS and PWR LEDs light
● The port LEDs flash