Before you Start
6 Quick Start for Hardware Installation: The Avaya C360 Converged Stackable Switch
● System administration
● Site security
● Site deliveries
Preparing Installation Files
Ensure that you load the latest versions of the firmware file for the C360. You can download the
firmware file needed for your installation from the Avaya Support Web site, at http://
support.avaya.com.
Preparing Needed Tools
Prepare the tools you need to mount the C360, according to the Table 1:
Choosing the Installation Site
Ensure that the location where you install your C360 fulfills the following requirements:
● Cables are away from sources of electrical noise such as:
● radio transmitters
● broadcast amplifiers
Table 1: Mounting Tools
If you need to mount on... Prepare these tools
Rack or wall Phillips head screwdriver
Flat wall screws to fasten C360 to the wall
Uneven wall
● 16.3" x 18.3" (415 x 465 mm) plywood board
0.8" (20 mm) thick
wood screws
● screws to fasten the C360 to the wall
To Next Page
Loading...
