Prepare for Configuration
28 Quick Start for Hardware Installation: The Avaya C360 Converged Stackable Switch
Configuring the Switch
This section describes the procedures for the first-time configuration of the Avaya C360. The
factory defaults are set out in detail in the tables included in this chapter.
You may configure the Avaya C360 using the text-based Command Line Interface (CLI), the
built-in Avaya C360 Device Manager or Avaya Integrated Management.
For instructions on the CLI, see the Avaya C360 Reference Guide.
For instructions on the use of the graphical user interfaces, refer to the C360 Device Manager
User Guide on the Avaya C360 Documentation and Utilities CD.
Avaya C360 Default Settings
The default settings for the Avaya C360 switch and its ports are determined by the Avaya C360
firmware. These default settings are subject to change in newer versions of the Avaya C360
firmware. See the C360 Release Notes for the most up-to-date settings.
Table 7: Default Switch Settings 1 of 2
Function Default Setting
IP address 149.49.32.134
Subnet Mask 255.255.255.0
Default gateway 0.0.0.0
Management VLAN ID 1
Spanning tree Enabled
Bridge priority for Spanning Tree 32768
Spanning tree version Common spanning tree
MAC aging Enabled
MAC aging time 5 minutes
Keep alive frame transmission Enabled
Network time acquisition Enabled, Time protocol
IP multicast filtering Disabled
802.1X system-auth-control Disabled
1 of 2
To Next Page
Loading...
