Label Control or feature Function
Blinking green indicates the system is in
sleep or ACPI S1 state.
No light indicates the power is off or the
system is in ACPI S4 or S5 state.
E Hard disk drive activity LED Random blinking green light indicates
hard disk drive activity.
No light indicates no hard disk drive
activity.
F System status LED Solid green indicates normal operation.
Blinking green indicates degraded
performance.
Solid amber indicates a critical or non-
recoverable condition.
Blinking amber indicates a non-critical
condition.
No light indicates POST is running or the
system is off.
G System identification LED Solid blue indicates system identification
is active.
No light indicates system identification is
not activated.
H System identification button Toggles the front panel ID LED and the
server board ID LED on/off. The server
board ID LED is visible through the rear of
the system and allows for server
identification and location when working
behind a rack of servers.
I Reset button Reboots and initializes the system.
J USB 2.0 Port Connector to attach a USB component to
the front of the system.
K NMI button When the NMI button is pressed with a
paper clip or pin, the server is placed in a
halt state for diagnostic purposes and
allows the issuance of a non-maskable
interrupt. After issuing the interrupt, a
memory download can be performed to
determine the cause of the problem.
L Front Video port Connector to attach a video monitor to the
front of the system. The front and rear
video ports cannot be used at the same
time however the front takes priority if both
ports are used.
1006r server description
12 Avaya CallPilot® 1006r Server Hardware Installation December 2010
To Next Page
Loading...
