Valid PCI card configurations
Introduction
There are three full size PCI-X card slots. Valid configurations of the PCI card slots are shown in
the table Table 1: 1006r PCI card slot configurations on page 16.
Note:
Your server configuration depends on what was ordered from Avaya. Therefore, your server
may not have all of the slots populated.
When looking at the server from the rear (see Back panel controls and features on page 13),
the PCI card slots are numbered from the top down.
Version Description
NTRH40CAE5 Has three RJ-45 connectors on its faceplate:
Connects to the CS 1000 or Meridian 1 with three standard RJ-45
Ethernet cables
For more information about these cables and connecting the
NTRH40CAE5 MPB96 board to MGate cards, see Communication
Server and CallPilot Server Configuration(NN44200-312) or
Meridian 1 and CallPilot Server Configuration(NN44200-302).
Table 1: 1006r PCI card slot configurations
Configuration Card slot
type
Slot
number
Position Card type Meridian 1*/ CS*
1000
Single MPB96 Full size FS_PCI-1 top MPB96 MGate 1, 2, 3
FS_PCI-2 middle Not used
FS_PCI-3 bottom Not used
Note:
When cabling to MGate cards, the RJ-45 connectors are numbered
from 1 to 3 on the NTRH40CAE5 MPB96 board starting from the right
side of the back panel (next to the power supplies).
Three MPB96
(High Capacity)
Full size FS_PCI-1 top MPB96 MGate 1, 2, 3
FS_PCI-2 middle MPB96 MGate 4, 5, 6
FS_PCI-3 bottom MPB96
1006r server description
16 Avaya CallPilot® 1006r Server Hardware Installation December 2010
To Next Page
Loading...
