10 11
1. Check that the are 2 charged AAA batteries
inside the remote control.
2. Unplug the codec unit from power.
3. Press the Back key and the OK
key together, until the small blue
LED on top of the remote quickly
flashes a few times.
4. While the LED light is still flashing, plug in the
codec unit.
1. On the CU360 screen, choose your preferred
language.
2. If a new build is available you can choose to
upgrade the device before continuing with
the setup.
3. Choose between “Yes, Avaya Spaces Room
App” or “No, Multiple Meeting Services”.
CU360 SETUP: QUICK SETUP
Note: You must keep the remote control close
to the unit. If the pairing is successful the LED
stops flashing. If the pairing fails, disconnect all
the cables from the CU, including USB and repeat
steps 1-4.
To Next Page
Loading...
