Avaya Inc. – External Distribution
3.4.3 Local Password Configuration - Password Security Enabled
For this configuration example, we will configure the following
Change the default read-write user name from RW to admin
Change the default read-only user name from RO to tech
Assuming Password Security is enabled by default
o This applies to secure version as Password Security is enabled by default on
SSH switch server
o With Password Security enabled, the password should contain a minimum of 2
upper, 2 lowercase letters, 2 numbers and 2 special characters like !@#$%^&*().
For admin, use the password AdminUser@#1234
For tech, use the password TechUser@#1234
ERS-STACKABLE: Step 1 – Add new user names and passwords
ERS-Stackable(config)# username admin stack rw
Enter password: ********* (AdminUser@#1234)
Confirm password: *********
ERS-Stackable(config)# username tech stack ro
Enter password: ********* (TechUser@#1234)
Confirm password: *********
ERS-STACKABLE: Step 2 – Enable telnet local authentication
ERS-Stackable(config)# cli password stack telnet local
ERS-Stackable(config)# cli password switch telnet local
To Next Page
Loading...
