Avaya Inc. – External Distribution
5.2 Use Management IP
By default, if Layer 3 is enabled, the switch will use the outgoing interface IP address when
attempting access to the RADIUS server. If you have multiple outgoing interfaces that can reach
the RADIUS server, normally you will have to configure your RADIUS server with each of
interface IP addresses used on the switch. However, the radius use-management-ip command
can be issued to tell the switch to use the switch management IP address for all RADIUS
requests independent of the out-going interface.
To enable RADIUS Management IP, please enter the following command
ERS-Stackable(config)# radius use-management-ip
To Next Page
Loading...
