Avaya Inc. – External Distribution
To reset the SSL server, enter the following command. If SSL is enabled, existing SSL
connections are closed while the SSL server is restarted and initialized with the certificate that is
stored in NVRAM.
ERS-Stackable(config)# ssl reset
To delete and generate a new SSL certificate, enter the following command. Please note the new
certificate is used only on the next system reset or SSL server reset. The new certificate is stored
in the NVRAM with the file name SSLCERT.DAT. The new certificate file replaces the existing
file. On deletion, the certificate in NVRAM is also deleted. The current SSL server operation is not
affected by the create or delete operation.
ERS-Stackable(config)# no ssl certificate
Old certificate is deleted on next system or SSL server reset
The WEB server demon can either be enabled or disabled by issuing the following command.
ERS-Stackable(config)# web-server ?
disable Disable HTTP access
enable Enable HTTP access
To enable WEB SSL authentication, enter the following command:
ERS-Stackable(config)# cli password <stack|switch> telnet <local|radius|tacacs>
To enable IP Manager control for WEB SSL access, enter the following command depending on if
IPv4 or IPv6 addressing is used:
ERS-Stackable(config)# ipmgr source-ip <1-50> <IPv4 address/mask>
ERS-Stackable(config)# ipmgr source-ip <51-100> <IPv6 address/prefix>
ERS-Stackable(config)# ipmgr web
To Next Page
Loading...
