Avaya G430 - IP Codec Set: Page 2; IP Codec Set; Related Topics

Related topics:
IP codec set: page 2 on page 31
IP codec set: page 3 on page 35
IP codec set: page 2
You can configure the following capabilities on the codec set:
• Enable or disable Direct-IP Multimedia for videophone transmissions.
• Enable or disable endpoints in the assigned network region to send fax, modem, or TTY
calls over IP trunks.
• Define the mode that the system uses to route the fax, modem, or TTY calls.
• Determine whether redundancy must be added to the transmission for higher reliability
and quality.
You must assign these capabilities to the codec set, and assign the codec set to a network
region for endpoints in that region to be able to use the capabilities established on this
screen.
Using V.150.1, you can configure fax and modem so that both use a relay mode together in
an IP codec set. You can set the FAX Mode field to t.38–standard for fax calls to use t.38.
However, modem calls use V.150.1.
Note:
Transporting modem signals over IP between Avaya Communication Manager systems and
media gateways is a proprietary implementation. The selection of the V.150.1 Modem Relay
codec choice is not proprietary. For modem transport interoperability with third-party
gateways, v150mr is the recommended mode of operation.
Related topics:
Allow Direct-IP Multimedia on page 32
Clear-channel Mode on page 32
FAX Mode on page 32
Maximum Bandwidth Per Call for Direct-IP Multimedia (units) on page 33
Maximum Bandwidth Per Call for Direct-IP Multimedia (value) on page 33
Maximum Call Rate for Priority Direct-IP Multimedia on page 33
Maximum Call Rate for Direct-IP Multimedia on page 33
Modem Mode on page 34
Packet Size on page 34
Redundancy on page 34
TDD/TTY Mode on page 35
IP codec set
Configuring V.150.1 on Avaya G450 and G430 Branch Gateway May 2014 31