from changing into fax mode, set the FAX mode to off and place the fax machines in an
Automatic Route Selection (ARS) partition that uses only circuit switched trunks, even for
inter-gateway fax calls.
Maximum Bandwidth Per Call for Direct-IP Multimedia (units)
This field appears only if Allow Direct-IP Multimedia is enabled.
Valid Entry Usage
kbits
mbits
The unit of measure corresponding to the value entered for bandwidth
limitation. The default measure is kbits.
Maximum Bandwidth Per Call for Direct-IP Multimedia (value)
This field appears only if Allow Direct-IP Multimedia is enabled.
Valid Entry Usage
1 to 9999 The bandwidth limit for Direct-IP Multimedia transmissions on this codec
set. The default value is 256.
Maximum Call Rate for Priority Direct-IP Multimedia
The system displays this field only if Allow Direct-IP Multimedia is set to y.
Maximum Call Rate for Direct-IP Multimedia
Use this field to limit the size of bandwidth used for video calls. The system displays this field
appears only if Allow Direct-IP Multimedia is set to y. The default value is 384 kilobits. You
can enter a value between 64 kilobits and 15360 kilobits, with an increment of 64 kilobits. A
typical video endpoint does not require more than 2048 kilobits.
IP codec set
Configuring V.150.1 on Avaya G450 and G430 Branch Gateway May 2014 33
To Next Page
Loading...
