Avaya Hirschmann MACH1040 - CLI Configuration

Avaya Inc. – External Distribution
ERS 5000 Series with Hirschmann™ IE Switches TCG
35
avaya.com
June 2011
7.3 CLI configuration
There are three switches to configure.
7.3.1 ES 470 configuration
The ES 470 uses the copper MLT ports 1/24 and 2/24 to connect to the ERS 5530 SMLT. The ES 470
uses only one VLAN on the stack (VLAN 1).
1
Enter Configuration mode and create a Distributed MLT on Copper ports:
470-24T(config)#mlt 1 enable member 1/24,2/24 learning disable
7.3.2 ERS 5530-Left
Note: This test designates 5530A as ERS5530-Left.
IST to 5530-Right are Copper MLT ports 23-24, VLAN 3999
SMLT to 470 are Copper MLT ports 13-14, VLAN 2
SMLT to Hirschmann™ are Copper/Fiber MLT ports 15-18, VLAN 3
IP Routing is enabled
VRRP is enabled
1
Enter Configuration mode and create IST Vlan 3999:
5530A(config)#vlan create 3999 name IstVlan type port
5530A(config)#vlan members remove 1 23-24
5530A(config)#vlan members add 3999 23-24
2
Create 470-vlan Vlan 2
5530A(config)#vlan create 2 name 470Vlan type port
5530A(config)#vlan members remove 1 13-14
5530A(config)#vlan members add 2 13-14
3
Create To-Hirschmann-Vlan Vlan 3
5530A(config)#vlan create 3 name ToHirschmann Vlan type port
5530A(config)#vlan members remove 1 15-18
5530A(config)#vlan members add 3 15-18