Avaya J169 - Page 243

Parameter name Default
value
Description
Value Operation:
• 0: Unblocked
• 1: Blocked
PHNNUMOFSA 3 Specifies the number of session
appearances the phone must
support while operating in a non-
Avaya environment.
Valid values are 1 through 10.
PHNOL 9 Specifies the outside line access
code. This is the number you press
to make an outside call.
Valid values are 0 to 2 dialable
characters (0-9, *, #).
PHONE_LOCK_IDLETIME 0 Specifies the interval of idle time, in
minutes, after which the phone will
automatically lock.
The phone will lock irrespective of
the value of
ENABLE_PHONE_LOCK.
PHY1STAT 1 Specifies the speed and duplex
settings for the Ethernet line
interface.
Value Operation:
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported
by hardware, otherwise auto-
negotiated
PHY2_AUTOMDIX_ENABLED 1 Specifies whether auto-MDIX is
enabled on PHY2.
Value Operation:
• 0: auto-MDIX is disabled.
• 1: auto-MDIX is enabled.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 243
Comments on this document? infodev@avaya.com